Encrypted EtherPoll Firmware History

This is the firmware revision log for the Encrypted EtherPoll.

NOTE: Due to the encryption in use, this firmware is not available for download. To obtain updated firmware for you EEP, please send an email to support@dcbnet.com . Updated firmware is available to registered users at no charge.


VERSION 1.03 5/24/2011 This corrected the following:

The Ping command did not function properly.



April 16, 2007 1.0 INTRODUCTION This version corrects a bug that did not allow the ports to be put into idle-timeout mode using the web interface; they were always forced back to transmit timer mode. (The previous work-around was to use the telnet or serial configuration mode). This version also has changes to prevent a bad network netmask from being entered.



January 11, 2007


This release corrects several minor issues.

The prior version's LEDs flashed like a regular EtherPoll; mostly blinking all of the time. Now the A and B LEDs flash on serial input or output.

The ports HTML help file improperly listed 460800 as a baud rate choice; that was reduced to 230400.

The Port Activity help file was clarified to show the direction of serial data flow.

The Config Summary Page now lists the firmware version. In addition, the old Config Summary Page improperly showed the secret passphrase. Now, if the passphrase is not blank, it shows up as "***", to keep the passphrase secure.



November 28, 2006

Initial public release.

Data Comm for Business Inc.
2949 County Road 1000 E
Dewey, Il 61840
Voice: 217-897-6600
Toll Free: 800-4-DCB-NET
Toll Free: 800-432-2638
Email: Contact Page
Web: www.dcbnet.com
Fax: 217-897-8023
All DCB web pages copyright ©1995- Data Comm for Business, All rights reserved.
EtherPath®, EtherSeries®, EtherPoll®, EtherBridge® and EtherModem® are Registered Trademarks of Data Comm for Business, Inc.